1 Heremai Street,
New Zealand, 0612
Phone: +64 9 835 0700
Unit 6, 2-8 South St,
NSW, Australia, 2116
Phone: +61 2 7200 9200
168 Robinson Road,
#12-01 Capital Tower
Phone: +65 6871 4140
Perfect chargers for any type of battery
Charge voltage can be precisely adjusted to suit any sealed or unsealed battery system.In particular, sealed maintenance free batteries must be charged correctly in order to ensure a long
service life. Overvoltage will result in excessive gassing and venting of a sealed battery. The battery will dry out and fail.
Suitable for AC and DC supply (AC-DC and DC-DC operation)
Except for the 3-phase input models, the chargers also accept a DC supply.
Every TG Charger has a microprocessor, which accurately controls the charging in three steps. The charging process takes place in accordance with the IUoUo characteristic and charges more rapidly than
Use of TG Chargers as a power supply
As a result of the perfectly stabilized output voltage, a TG Charger can be used as a power supply if batteries or large buffer capacitors are not available.
Two outputs to charge 2 battery banks (24 V models only)
The TG Chargers feature 2 isolated outputs. The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to top up a starter battery.
To increase battery life: temperature compensation
Every Skylla TG Charger comes with a battery temperature sensor. When connected, charge voltage will automatically decrease with increasing battery temperature. This feature is especially recommended for
sealed batteries which otherwise might be overcharged and dry out due to venting.
Battery voltage sense
In order to compensate for voltage loss due to cable resistance, TG Chargers are provided with a voltage sense facility so that the battery always receives the correct charge voltage.
|Model||Input Voltage Range (VAC)||Input Voltage Range (VDC)||Battery Capacity (Ah)|
|Input voltage (VAC)||230 V or 3X400 VAC|
|Can be used as power supply||YES|
|Remote alarm Forced cooling||Potential free contacts 60 V / 1 A (1x NO and 1x NC)|
|Protection||Output short circuit
Battery reverse polarity detection Battery voltage too high
Temperature too high
|Operating temp.||-40 to +50°C (-40 – 122°F)|
|range Humidity (non condensing)||max 95%|